Pyronix PCX 256 Manuale Utente Scaricare il pdf (Pagina 15)

ault Indications / Unable to Arm

Any faults that occur on the system will

be easily recognised by the ashing

ALERT LED

If ‘unable to arm’ is displayed, it

indicates that an input is already active

and the area where the input is should

be checked for open windows, pets,

movement etc.

If the problem cannot be solved

contact your engineer, or omit the

input (page 16)

Fault Indications

Unable To Arm

To see what the fault is, a valid user

code needs to be entered.

Depending on how the system has

been set up by your engineer, it may be

possible to arm the system with a fault,

to do this press the key and following

instructions on page: 7 for partition

systems or page: 9 for level set systems.

Possible faults that may be displayed on the keypad:

Modem fault 100, Digi Fail Comm, PHC Test Fail, Line Fault 100, ATE Line Fault, ATE

Fail Comm, Device Fail ###, 485/Comms Lost, SAB Tamper, Case Tamper, Battery

Fault, Mains Fail or any other faults that appear that you are unsure of.

The faults mentioned above may aect the overall performance of your PCX

system, if any of the above are displayed you should contact your enginner

immediately.

IMPORTANT: Make sure that you

engineer is informed when a fault

occurs on the system.

Pyronix

Time 10:34 c

Alarm Silenced

Battery Fault100

Unable to Arm

Input 005

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Nessun commento

Pyronix PCX 256 Manuale Utente Pagina 15